La instalación de la piscina:
1.Pulido (después del tratamiento a prueba de agua, pulido y nivelación)
Vaciar la piscina completamente. Chip, moler o bujarda distancia cualquier puntos altos a lo largo del revestimiento de la piscina. Mella escombros de alrededor de las tuberías y las luces con un martillo luz astillado.
2.Toda la piscina está dosificado con una capa de cemento.
Limpiar toda la superficie de la piscina con una manguera de jardín equipado con una boquilla de presión. Salir de la piscina que se seque hasta que la superficie aparece húmeda pero no hay humedad visible en la superficie. Esto se conoce como superficie seca saturada.
3.Mosaicing
Dampen the surface of the pool to saturated surface dry again. Clean the back side of the tiles to remove any dust resulting from the manufacturing process.
Mix glass mosaic tile adhesive with water at a ratio of 3 a 1. Continue mixing to a creamy consistency and then leave the mix to stand for 5 minutos. Stir again and then use immediately. Do not mix more adhesive than you can use in 15 minutes or it will begin to set before installation and will not bond efficiently with the tiles.
4.Grouting
Cover the pool. Leave the adhesive to cure according to manufacturer’s instructions, checking often to determine when it is fully cured. Temperature, humidity and wind conditions will affect the drying process and you cannot proceed with grouting the tiles until the adhesive completely cures.
Moisten the tiles with a damp sponge. Grout the tile with an epoxy grout mixture and a rubber grout float held at a 45-degree angle. Gently scrape away any epoxy grout on the surface of the tiles with the grout float held diagonally.
5.Cleaing
